Skip to main content

Pro+ 13×13 Motorized Freestanding Pergola (Post-to-Post Measurement – Double Bay)

This article provides accurate structural measurements for the Pro+ 13×13 (4×4 m) Motorized Freestanding Pergola – Double Bay. Use these values to plan concrete footers, verify spacing, and ensure proper alignment during installation.

Updated this week

📏 Post-to-Post Measurements – 4 m (13 ft) Side

Measurement Type

Description

mm

in

ft

Outer to Outer Post

Full width between outer post edges

3945 mm

155.31 in

12.94 ft

Outer to Inner Post

Outer edge → inner edge of opposite post

3825 mm

150.59 in

12.55 ft

Inner to Inner Post

Clear open space between inner post faces

3705 mm

145.87 in

12.16 ft

💡 Tip: Use the 3945 mm (12.94 ft) outer-to-outer dimension when marking corner locations to keep your frame square.


⚙️ Baseplate-to-Baseplate Measurements – 4 m (13 ft) Side

Measurement Type

Description

mm

in

ft

Inner to Inner Baseplate

Between inner edges of baseplates

3645 mm

143.50 in

11.96 ft

Outer to Inner Baseplate

Outer edge → inner edge of opposite baseplate

3825 mm

150.59 in

12.55 ft

Outer to Outer Baseplate

Full span across outer edges

4005 mm

157.68 in

13.14 ft

💡 Tip: Use 4005 mm (13.14 ft) to lay out baseplate anchors — this is your true corner-to-corner spacing on each side.


📐 Post Height Measurements

Measurement Type

Description

mm

in

ft

Post Edge (ground) → Beam

Ground to bottom of beam

2330 mm

91.73 in

7.64 ft

Outer to Outer Post Height

Ground to top of beam

2503 mm

98.54 in

8.21 ft

Post Edge (ground) → Open Louvers Top

Maximum height with louvers open

2560 mm

100.79 in

8.40 ft

💡 Tip: Allow at least 100 mm (≈ 4 in) clearance above the open louvers for safe operation and air flow.


⚡ Motor and Power Clearance

  • Leave 50 mm (≈ 2 in) of clear space on the motorized beam side for housing and wiring.

  • Place a power outlet within 1.5 m (≈ 5 ft) of the control box.

  • Keep cables accessible before attaching roof panels.


🧩 Installation Planning Tips

  1. Mark post corners using the outer-to-outer post dimension (3945 mm).

  2. Verify diagonals before pouring footings — both should be equal to ensure a square frame.

  3. Recommended footer: 400 × 400 mm (16 × 16 in) × 400 mm deep (16 in).

  4. Leave 30 mm (1.2 in) tolerance around post anchors for alignment adjustments.

  5. Level all posts first before securing the roof frames or motor components.

  6. Confirm motor functionality and louver movement before final tightening.

  7. Re-check clearances to avoid wall or furniture obstruction when louvers open.


📐 13x13 Pro+ Motorized Freestanding Pergola — Post-to-Post Measurements

Need the exact post spacing for your 13x13 Pro+ Motorized Freestanding Pergola?
View 13x13 Motorized Freestanding Post-to-Post Measurement Guide (PDF)

Did this answer your question?